Please wait while the page loads...

Check Engine Light Service 2019 Ford Fusion

What do you do when you’re driving along in your Ford Fusion and suddenly, a yellow light brightens on your dash and says "Check Engine". If you’re like most Ford owners, your heart sinks a small because you have small idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t imply you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2019 Ford Fusion checked as soon as practical. Ignoring that warning could end up causing primary damage to expensive engine components.

When your 2019 Ford Fusion's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t proper, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Ford auto repair mechanics at Coggin Deland Ford. There are also a number of comparably proper code readers that are designed for do-it-yourselfers, should you select that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced expert to learn the issue and repair it.

2019 Ford Fusion Check Engine Light

If the check engine light in your 2019 Ford Fusion starts blinking, that means that the problem needs hasty attention and your Ford should be brought in today. A blinking light expresses that the problem is hazardous and if not taken care of today may result in gargantuan damage to the automobile. This blinking light usually indicates a scrupulous engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can suddenly raise the temperature of the catalytic converter to a point where wear and tear is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can precisely be the cause. A bad, classic or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a immensely expensive repair. If your check engine light is flashing, please contact our company of automotive consultants at Coggin Deland Ford abruptly by calling 3862100247.

2019 Ford Fusion Check Engine Light Flashing

Although there are bountiful potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are innumerable amicable causes including something as traditional as a loose gas cap. Substitute amicable reasons for a Check Engine Light are dirty mass airflow sensor, a malfunction with the fuel injection system, damaged oxygen sensor, faulty head gasket, faulty emissions control part, or defective spark plugs to name some. No matter what is the root cause of the Check Engine Light, we have the Ford Certified Technicians and the certified service protocol to isolate the root problem and repair it as paramount to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ford issue was fixed.

Every 2019 Ford Fusion was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its draconian systems. The sensors are continually detecting conditions while sending data to the mechanical control unit. If the mechanical control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is unsound nor what to do about it. That’s where we come in; Coggin Deland Ford provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Hugely Qualified Service expert.

Is it safe to drive your 2019 Ford Fusion with the check engine light on?

This question is not very pure because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be secure to drive. This is consistently indicated by a persistent glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more harsh problem. If the check engine light is glaring, this means that there is a harsh issue and it is recommended to service your Ford Fusion expeditiously. Call the experts at Coggin Deland Ford by dialing 3862100247 so you can describe the issues. Or reduce your speed and bring your 2019 Ford to our certified mechanics as soon as attainable.

What could cause the check engine light to come on in a 2019 Ford Fusion?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a risky problem that could cause risky damage to your engine and come with a memorable repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow usually means something less risky but a flashing check engine light indicates that your vehicle’s engine is in risky trouble and service is imperative immediately. If your check engine light is flashing in your 2019 Ford Fusion, we extremely recommend not to drive the vehicle and schedule Ford service now. Below is a list of the most common reasons your check engine light can come on:

  • The battery is low or dead. The battery in your 2019 Ford Fusion is every needed. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't actually require maintenance. The price of a new one depends on the type of Ford you travel to work, but check our current service coupons and specials.
  • Your catalytic converter is detrimental or going detrimental. The catalytic converter is a part of your 2019 Ford Fusion’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is customarily caused by neglected maintenance, which is why Coggin Deland Ford offers a complimentary multi-point inspection with every Ford service. If you have an issue with your catalytic converter and don't get it repaired, your 2019 Ford Fusion will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause alternative problems from overheating.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or alternative item can wreak havoc on your 2019 Ford Fusion if it’s not installed properly. These aftermarket parts and accessories can discharge the battery, trigger the check engine light, or even prevent the car from starting. If these issues sound accepted, deliver your Fusion to Ford and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might cost a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • One of the most ongoing and frequent cause is that your 2019 Ford Fusion gas cap is loose, damaged or missing. The gas cap for your 2019 Ford Fusion serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a detrimental fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on promptly after you put gas in your 2019 Ford Fusion, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your 2019 Ford Fusion has a vacuum leak. Every Ford Fusion has a vacuum system that performs a wide collection of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to important heat or extreme chilled.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ford Fusion is what determines how much fuel is needed to run your engine efficiently by measuring the sum of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to solid changes, like altitude. If your Ford Fusion is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a detrimental mass airflow sensor.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, accepted as the O2 sensor, measures the sum of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your car will be less rational when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2019 Ford Fusion's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to suggest the correct mixture of air and fuel that enters the cylinders in your engine. A detrimental O2 sensor can also cause a car to fail an emissions test.
  • New Spark Plugs or Plug Wires are needed for your 2019 Ford Fusion. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are detrimental or old, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, best to more expensive repairs.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not accurately tightened to a more relentless failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it favorable to get the fitting code reading and diagnosis. The average cost for a check engine light diagnosis & testing is normally between $88 and $111. The favorable news, Coggin Deland Ford offers complimentary multi-point inspections and free diagnostics, in most cases, to aid mean the cause of your check engine light.

Will the check engine light reset itself?

The check engine light on your 2019 Ford Fusion will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going suitable, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2019 Ford Fusion light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Coggin Deland Ford so the light and code can be double-checked and reset.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we suggest that you pull over and contact Coggin Deland Ford to help represent if your vehicle is legitimate to drive in or if we suggest a tow truck. The safest bet is to decipher the code and then plan your strategy properly. It could be anything from a bad sensor to plug wires needing to be replaced. Since each check engine code has its own level of severity, it is not easy to predict how frequent miles you can drive with the warning light on.

2019 Ford Fusion Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that tiny light on your vehicle’s dashboard suddenly lights up, but in reality, it is not something that should cause you to shut down in fear feasible away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Fusion. There are hundreds of different codes that your check engine light can determine. While that sounds daunting, with a tiny patience, tackling accessible diagnostics will give you equitable knowledge about your automobile and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, realistic and helpful automobile symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of viable OBD codes, there are also hundreds of viable reasons for the light, including:

  • Emissions controls issues
  • Computer output circuit issues
  • Ignition system faults
  • Loose Gas Cap or Missing Gas Cap
  • Fuel and air metering systems problems
  • Transmission issues
  • Bad Spark Plugs
  • Old Battery
  • O2 Sensor

This is why it is decisive for someone who does not have a few of automotive knowledge to not assume what a code means. If the engine light comes on due to a harsh concern, you risk contentious your car supplemental by not repairing the issue correct away. Call Coggin Deland Ford at 3862100247 straightaway or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out abruptly by a certified Ford mechanic.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2019 Ford Fusion is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few divergent ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2019 Ford Fusion. Some of these include shifting automatic transmissions ignition timing, controlling engine speed, and implementing stability control, just to name a bit. With that being said, the check engine light can mean a variety of divergent things. It can be as plain as your gas cap being loose or as relentless as engine knocking. If your check engine light is on in your 2019 Ford Fusion, contact Coggin Deland Ford. Our Ford service department can help you find out what code is turning your check engine light on or inspect why your check engine light is flashing. Contact Coggin Deland Ford today!