2020 Ford Transit Van Check Engine Light Codes
The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly lights up, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also acceptable as the OBD (on-board computer diagnostic system) in your Transit Van. There are hundreds of distinct codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you decent knowledge about your vehicle and will also allow that Check Engine Light to do what it is genuinely supposed to do: be your guide. Unfortunately, indisputable and cooperative vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of rational OBD codes, there are also hundreds of rational reasons for the light, including:
- Computer output circuit issues
- Old Battery
- Loose Gas Cap or Missing Gas Cap
- Emissions controls issues
- Ignition system faults
- Transmission issues
- Bad Spark Plugs
- O2 Sensor
- Fuel and air metering systems problems
This is why it is dangerous for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Coggin Deland Ford at 3862100247 straightaway or schedule your check engine light service online today! If the engine light comes on due to a rigid concern, you risk damaging your car extra by not repairing the issue right away. When your check engine light comes on, you should get it checked out quickly by a certified Ford technician.
What could cause the check engine light to come on in a 2020 Ford Transit Van?
When your check engine light comes on, this could be as classic as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a critical problem that could cause critical damage to your engine and come with a gigantic repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow mostly means something less critical but a flashing check engine light expresses that your vehicle’s engine is in critical trouble and service is basic immediately. If your check engine light is flashing in your 2020 Ford Transit Van, we extremely recommend not to drive the vehicle and schedule Ford service today. Below is a list of the most classic reasons your check engine light can come on:
- Issues with any aftermarket items. An aftermarket alarm, exhaust or alternative item can wreak havoc on your 2020 Ford Transit Van if it’s not installed properly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even avert the vehicle from starting. If these issues sound pure, bring your Transit Van to Ford and have our team of certified mechanics ensure that your aftermarket items were installed properly and aren't causing any issue. Getting accessories, notably aftermarket parts and accessories, or using OEM parts first place might price a meager bit more but could save you money from having to get poor work and wear and tear caused by poor installation work corrected.
- One of the most prevalent and plentiful cause is that your 2020 Ford Transit Van gas cap is loose, damaged or missing. The gas cap for your 2020 Ford Transit Van serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on hastily after you put gas in your 2020 Ford Transit Van, first thing you should check is to make courageous the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
- The battery is low or dead. The battery in your 2020 Ford Transit Van is each amusing. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't genuinely require maintenance. The rate of a new one depends on the type of Ford you drive, but check our natural service coupons and specials.
- Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2020 Ford Transit Van’s exhaust system. The catalytic converter's work is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Coggin Deland Ford offers a complimentary multi-point inspection with each Ford service. If you have an issue with your catalytic converter and don't get it repaired, your 2020 Ford Transit Van will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause alternative problems from overheating.
- Your 2020 Ford Transit Van has a vacuum leak. Each Ford Transit Van has a vacuum system that performs a wide assortment of functions. The vacuum system also helps lower damaging emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can arid out and crack, notably if they’re exposed to important heat or extreme chilly.
- Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, acknowledged as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less adequate when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause wear and tear to your catalytic converter and your 2020 Ford Transit Van's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
- Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ford Transit Van is what determines how much fuel is fundamental to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to affectionate changes, like altitude. If your Ford Transit Van is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
- New Spark Plugs or Plug Wires are fundamental for your 2020 Ford Transit Van. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or wear and tear to ignition coils and O2 sensors, extensive to more expensive repairs.
How much does it cost to get the engine light checked?
The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more strict failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it marvelous to get the correct code reading and diagnosis. The middle cost for a check engine light diagnosis & testing is typically between $88 and $111. The marvelous news, Coggin Deland Ford offers complimentary multi-point inspections and free diagnostics, in most cases, to help opt for the cause of your check engine light.
2020 Ford Transit Van Check Engine Light Flashing
Although there are countless possible causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are copious natural causes including something as easy as a loose gas cap. Other natural reasons for a Check Engine Light are faulty emissions control part, faulty head gasket, dirty mass airflow sensor, damaged oxygen sensor, a malfunction with the fuel injection system, or defective spark plugs to name copious. No matter what is the root cause of the Check Engine Light, we have the Ford Certified Technicians and the certified service protocol to isolate the root problem and repair it as necessary to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ford issue was fixed.
Every 2020 Ford Transit Van was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its laborious systems. The sensors are continually detecting conditions while sending data to the electrical control unit. If the electrical control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Coggin Deland Ford provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Immensely Qualified Service experienced.
How many miles can you drive with the check engine light?
Since each check engine code has its own level of severity, it is difficult to predict how many miles you can travel to work with the warning light on. The safest bet is to decipher the code and then plan your strategy properly. If you check engine light is twinkling, we advocate that you pull over and contact Coggin Deland Ford to help determine if your vehicle is safe to travel to work in or if we advocate a tow truck. It could be anything from a harmful sensor to plug wires needing to be changed.
What Does the Check Engine Light Mean?
One of the most typically misunderstood lights or indicators in your 2020 Ford Transit Van is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a lot clear ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light flashes in either an amber or red color and is part of the diagnostics system found on your car. Onboard computers increasingly have controlled and monitored car performance since the 80s and do a variety of things for your 2020 Ford Transit Van. Some of these include controlling engine speed, shifting automatic transmissions ignition timing, and implementing stability control, just to name a few. With that being said, the check engine light can mean a assortment of contrasting things. It can be as straightforward as your gas cap being loose or as risky as engine knocking. If your check engine light is on in your 2020 Ford Transit Van, contact Coggin Deland Ford. Contact Coggin Deland Ford today! Our Ford service department can help you read what code is turning your check engine light on or investigate why your check engine light is flashing.
Check Engine Light Service 2020 Ford Transit Van
What do you do when you’re driving along in your Ford Transit Van and suddenly, a yellow light brightens on your dash and says "Check Engine". If you’re like most Ford owners, your heart sinks a small because you have small idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2020 Ford Transit Van checked as soon as available. Ignoring that warning could end up causing major damage to expensive engine components.
When your 2020 Ford Transit Van's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the mechanical control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is continually labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”
When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electrical inspect tool that is used by our Ford auto repair mechanics at Coggin Deland Ford. There are also a number of relatively correct code readers that are designed for do-it-yourselfers, should you opt for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an licensed professional to opt for the issue and repair it.
Will the check engine light reset itself?
The check engine light on your 2020 Ford Transit Van will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2020 Ford Transit Van light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Coggin Deland Ford so the light and code can be double-checked and reset.
2020 Ford Transit Van Check Engine Light
A twinkling light illustrates that the problem is critical and if not taken care of straightaway may result in extensive damage to the vehicle. If the check engine light in your 2020 Ford Transit Van starts twinkling, that means that the problem needs swift attention and your Ford should be brought in straightaway. This blinking light usually hints a exacting engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can abruptly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can totally be the cause. A harmful, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our unit of automotive experts at Coggin Deland Ford straightaway by calling 3862100247.
Is it safe to drive your 2020 Ford Transit Van with the check engine light on?
If the check engine light is twinkling, this means that there is a dangerous issue and it is recommended to service your Ford Transit Van instantly. This question is not highly simple because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be protected to drive. This is commonly indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more intrusive problem. Call the experts at Coggin Deland Ford by dialing 3862100247 so you can describe the issues. Or decrease down your speed and transport your 2020 Ford to our certified mechanics as soon as possible.